About bvogle

bvogle · 05-10-2017

Can SNTC look at the configs of devices in an inventory upload to better determine if PSIRT alerts apply to the devices? Based on what i've found it appears that device model and image name are the primary means by which a PSIRT comparison is made. ...

bvogle · 03-20-2017

When i attempt to access the total care portal, i'm immediately redirected to a page that asks me to register (see below). I've had sporadic access recently (https://supportforums.cisco.com/discussion/13237546/unable-log-portal).

bvogle · 03-01-2017

Since at least last Friday, i've been unable to log into the SNTC portal. It acts as if i'm not registered. I'm assuming it's because of this message, but i thought it would be worth asking. The SNTC portal is currently experiencing an issue that ...

bvogle · 01-03-2017

We had an old 2.2 CSP collector that was discovering and uploading to our SNTC portal. I attempted to upgrade the 2.2 collector but it kept failing so i replaced the collector with a 2.6 CSP collector. The collector is discovering and performing in...

bvogle · 12-03-2004

I would like to monitor the number of active calls on a PRI connected to a 2621XM (code level 12.3(8)T5) via SNMP. Does anyone know an OID that would work? Everything I can find refers to CISCO-POP-MGMT-MIB, which doesn't appear to be supported on ...

bvogle · 07-14-2017

I receive the same error when attempting to save a duplicate of the default Hotspot portal. Does not occur if i create a new hotspot portal. ISE 2.1, patch 3 with "ise-applystrutsfix-signed.x86_64.tar.gz" applied. Language is English.

bvogle · 03-01-2017

Mesage sent.

bvogle · 01-04-2017

Ah, that does look like it. I see the uploads now, but they are two weeks behind between the upload date and the process date. Is that to be expected? We're currently uploading daily, but if there is that big a gap on average, we'll adjust to less...

bvogle · 08-12-2005

I was having this exact problem. I had to add the "direct-inward-dial" command to one of my outbound dial-peers. Once i did that, it works perfectly.

Member Since	‎09-10-2002 08:14 AM
Date Last Visited	‎08-24-2018 02:02 AM
Posts	9

User Statistics

User Activity

SNTC PSIRT Report and Device Configs

Unable to Access Portal

Unable to Log into Portal

SNTC - CSP Collector Information Not in Portal

SNMP OID for Gateway Utilization

I receive the same error when

Mesage sent.

Ah, that does look like it.

Re: CallManager Express Won't forward T1 DID