Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good afternoon,I understand that it is not possible to simply upload a 4400-series config file to a 2504 (worked OK 4400 to 5508 but that's another story): I've also tried it and failed.But does anyone have any suggestions for migrating the 378 filte...
Good morning,We have a customer with a 5508 controller running 7.4.110.0. It has a backup image of 7.2.111.3.When we added a 1242 access point to it recently the access point was offered the wrong image version: it was offered and downloaded 7.2.111...
Good morningTo keep costs down a customer of ours wants to use WAP121s as workgroup bridge clients in place of WET200.I know that certain of the enterprise WAPs running autonomous IOS can act as properly integrated bridges in a WLC environment (113...
Good morningTo keep consts down a customer of ours wants to use WAP121s as workgroup bridges in place of WET200.I know that certain of the enterprise WAPs running autonomout IOS can act as properly integrated bridges in a WLC environment (1130s, 1142...
Do the power supplies in Cisco switches have any built-in self protection? I've been unable to find any references on the web.The reason that I ask the question is that we have had several cases of switches losing power - sometimes but not always af...
But won't the APs rejoin when the primary comes back up again?Also - can you have a HA pair with different versions (unless you've de-HAd them)?The APs compare their booting image with the WLC when they join the WLC - if they find the WLC has a diffe...
Yes, I see what you mean.After writing this it also occured to me that I could try downloading the config file from both machines and transferring the appropriate sections from the 4400 config to the 2504 config before uploading it again.Thanks for y...
Not sure that you can do that - how do you want to see how the APs behave?The problem is the AP has to have the same version running as the controller: so you can push the upgrade out but the AP will not use it "live".If you reboot the WLC then all t...
Just to add to this, we hit the same problem with a 5508. Cisco TAC sent us the RTOS image which re-installed 7.0.116.0 firmware, however every time I run the 1.9.0.0 FUS I see the same problem: it's fully repeatable. I'm fully aware of the instruc...
