Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This was a solved issue years ago. Failover would never work because there was a notification page that would "confuse" the MX that is not down by spoofing all failover tests preventing cell failover to kick in. The solution was to disable the Broadb...
I have some AIR-ANT2566P4W-R= that I will use for deployment between racks in a warehouse. Wall-mount is not practical due to positioning and distance of said racks. Can these be installed in the ceiling?
You can disable it and that was the original fix to this issue, but recently AT&T decided to enable it remotely. So if you disable it now and check back a few days later its enabled again.We did contact them back. They say everything is working as it...
The problem is that the MX also checks for DNS and HTTP so the MX asumes is up since the modem replies to the DNS and HTTPS quieries. From that Document:"...Failover Connectivity TestsThe MX runs the following tests to determine uplink status:DNS tes...
The amplifier detection error is unique to the unit that reports EQX, we have another unit reporting correctly as EQ that has the amplifier working fine. So it appears that this mis-representation is creating this error with the amplifier.
