t.svatek
Level 3
Level 3
Member since ‎04-28-2005
‎02-23-2024

User Statistics

  • 190 Posts
  • 1 Solutions
  • 262 Helpful votes Given
  • 75 Helpful votes Received
Recent Badges
First Discussion
70 Discussion Posts
60 Replies
40 Discussion Posts
40 Helpful Vote
40 Replies
50 Helpful Vote
5 Discussion Posts
5 Helpful Vote
50 Discussion Posts

User Activity

Hi   Is there a way on Room 70 to route the local microphone signal to an output to connect a recorder?   Thanks, Tino
Hi,   I tried to upgrade to 8.6, but a connected 3500 AP will no longer work. When I start the upgrade on the 1815i controller, I see on the TFTP server that the file ap3g1 is not found. With version 8.5 everything works fine and I see a lot more fil...
Hello CiscoUsing the history Service API, I can see the following PSTN Audio types (I have changed the names a bit to clearfy what it is)bridgeCountryTollCallInglobalCallMeBackbridgeCountryCallMeBackbridgeCountryTollFreeCallInThe following types are ...
Do the GPIOs on the SX80 have a galvanic isolation (including the GPIO-GND and +12V) against the rest of the device and it´s power supply? Or do I have to use an extra optocoupler or relais to achive this? thanks Tino
HiThe EX90 Admin Guide states, that either a Headset or the Cisco TelePresence Table Microphone 20 can be connectet to the 3.5mm input on the rear.These two microphone types are quiet different:Headset: has a 3.5mm mono connector plug, asymmetric out...
Community Statistics
Member Since ‎04-28-2005 05:50 AM
Date Last Visited ‎02-23-2024 12:04 AM
Posts 190
Total Helpful Votes Received 69