Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a UC540 setup to call a cell phone for voicemail notification. The outbound call works great assuming the user can pickup the call within about 4 seconds. After about 4 seconds the call terminates. I have changed the hang up timer but the call...
I have a UC320 that we are using for demos. I performed a factory reset on the unit to prepare for a fresh install.Now after logging in with cisco/cisco I am shown the "loading new configuration" however it never goes any further.In capturing packets...
I used the CCA 3 for initial setup of a new site.I let it use the default IP range for the voice vlan initially and later went back and changed it. After the change the phones will not pick up an address via dhcp. If I hard code them they never regi...
I have a customer moving from a 5505 to a 5510. They are currently running websense express, which monitors and filters traffic based off of a port mirror on the ASA. Can this function still be performed on the ASA5510? If so, I am having trouble fig...
Hello,I have a customer who is getting a UC560. He needs three operator consoles for the site.Because the Smart CallConnector operator option is limited to two operators, I am not sure how to meet his needs.I know the server product would allow thre...
Hey Alex, thank you for the reply.Currently I have it set at 90 seconds, below is the output. If the outbound dialing was accounting for most of that time I would expect that by moving the time to a lower value the phone would ring a shorter period o...
I did, I had to call the small business support group and have them reload everything.They logged into a web page on the box that we as consumers do not have access to and was able to restore it.I really wish access to the advanced pages would be giv...
Resolved...Not sure where they came from but there were excluded-address statements which included the entire range for that subnet.Deleted those and everything works as planned.Of course, where did the statements come from though....
Thanks, but problem with that is the product I am using is websense express. Express only supports the port mirrored method for filtering and monitoring.Appreciate it though
