Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,please support to get this issue resolve. I have Firepower 2130 and trying to upgrade the firmware of the device from (6.3.0.4-44) to (6.3.5 or 6.4.0). however when I choose the firmware file and click on install button device complete...
Hello, I have an issue with C6807 switch am trying to configure the VSS on 2 x C6807 switches to make them a single unit, however both switches are getting synched but in switch A module 4 is not working fine, I tried to insert and module many times ...
Hi,can anyone please help to get this issue fixed, I have C6807-XL Modular Switch, and trying to make them single unit however, SW-B is working fine, and SW-A is not working properly, when I finish the VSS configurations on SW-A it required reload. a...
Hi everyone,I have an issue while configuring the VSS on C6807 switches. can anyone please help and guide me how to solve this issue, Switch A&B configurations are not getting synched its not working as a single unit. please help...CORESW-ALAN-CORE...
Hi Everyone,here I would request to all that please support we are unable to get the MOH and DND features on VOIP phones as here below shown we have configured the Exte#113 and same Ext#114 for the with similar configurations tempelate on CUCM. pleas...
Hi Marvin,thanks for your comments, issue was resolved when I tried to upgrade the firmware via cli. it was creating issue with gui later I tried to upgrade the the firmware in command line. thanks for your comment appreciated.
Here is the output when I have to enter the boot command after reload or power up of the switch. rommon 1 > boot#Booting s6t64-adventerprisek9_npe-mz.SPA.155-1.SY4.bin ...###############################################################################...
Hi @Leo Laohoo I follow the procedure of FPGA you recommended, but its fail when I run the following commands, and do you why Module 4 went into rommon mode and I have to command boot to bring it back. is there any solution please ?as switch is not ...
@Leo Laohoo I am afraid to say don't know the procedure of the FPGA cause am doing this first time, however if you have steps to perform specifically in this case please share with me I will follow that one. thank you.
