Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Does anyone know what is the packet per second threshold for sup2-2ge?The data sheet states it can run up to 30mpps. How to calculate this in production network?
Hi Cisco,How to factory reset C40?The problem is that someone accidentally disabled the infrared between the codec and the remote control.How to re enable back the infrared so that we can access the C40 menu options again?Thanks
Hi All,Is it possible for ACS 5.1 to only allow specific AD users to authenticate the switches and routers?Currently What I have configured is onlyfor all AD users. I can't seem to find a way to be selective.ThanksRegards
Hi everyone,I have a very "interesting" que from my customer.He is asking me how much disk space is needed for an event log. Just one event log. Because I told him that IPS itself has limited space for logs and to archive it, please use IME installed...
Hi,If I have switchports on Nexus N2K connecting to servers and I am running vPC, May I know should I configure both the Port-Channel and physical switchports with spanning-tree port type edge or just configure that on the Port-Channel.What is the be...
Hi Joseph,Thanks for replying!How do check if the cat6k is hitting 30mpps? is there any cmd to check this? or we have to add up all the ports mbps then convert them to pps to verify?Thanks
Hi Guys,I did used the system username and allocated the ACS default of deny/access for the shell profile and command set is also ACSDefault deny all commands. But still that particular username still able to login into the switches .What could have ...
