Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The ASA command equivalent to see this sort of info would be "show switch mac-address-table".I can run an arp request on the MX, but that is close to useless since it only list.. well ARP .. ip to mac... no interface info is given.Anyone found a way ...
I am trying to replace an old Cisco ASA5505 with a Cisco892fsp.On the LAN - besides hosts etc. - is an Apple Wireless setup (Airport Extreme as main and some Airport Express as extenders)The Wireless setup is announcing 2 SSID´s - One for local LAN a...
I have a VPN3030 set up strictly for remote access users only. (using preshared keys & running 3DES-MD5).Problem is, that the vpn3030 hits 100% cpu load, at only ~ 6Mb thrughput ~150 sessions. Is it possible to get detailed information on the CPU usa...
Seeing the same issue here... Version 13.33 - It´s almost like a "hickup" everytime it needs to start...Aug 19 17:50:59 Intrusion detection startedsnort_rules_version: 2.9.8.3, source: ids-vrt-balanced, rules: 828397756caef914fe42dc8bbb53da58b6815a2e...
@Philip D'Ath Ok, I haven´t tried it on the new 5506-x, but was kinda expecting the command to work as it did on the 5505.. have you verified the absence of the command on the 5506-x? - Otherwise I will check myself whenI get around to it.br /Ole
I might be relativly new to Meraki, but im far from new to the Classic and Security portfolio, and I assure you, That the command “show switch mac-address-table” is very much an ASA “thing”!On the smaller platforms (Those With a build in switch modul...
I Know this is an old thread, but somebody may find it usefull someday. - I experienced the same behavior today... it turned out, that one of the peers had a wrong (wider) subnetmask
