Hi all,I have a problem of making a trunk between catalyst 3560 and AT 8324. Both are 1 Gbps link and below is the configuration of the catalyst switch.interface GigabitEthernet0/5 description trunk to ALLied_TELESYN switchport access vlan 5 switchpo...

Hi All,I am new to network Design and would like to have guidance from the gurus.The Lan i am designing consists of 500 people with 5 Floors.I am planing to have each VLAN for each Floor.On Core Catalyst 4506 is selected ( For redundancy). No distrib...

Hi All, I have some trouble regarding the QOS implementation for the VOICE communication.I tried to setup the low latency queuing but it showed that it is weighted fair queuing.I want to apply the strict policy ( reserved the bandwidth) of 128 k for...

Dear All,I got a problem regarding the OPSF convergence Our mail link goes down and OSPF converged to the Backup link and now when main link goes up OSPF is not converging to main route.below is the partial output of sh ip ospfArea BACKBONE(0) (Inact...

Hi All,Currently i am facing trouble in maintaining the VPN connection.This VPN is in Aggressive Mode ( PIX to PIX Dynamic-to-Static IPSec with NAT)Now problem is that VPN connection disconnected when it goes Idle.We are using this VPN for the voice ...