Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Quick question is What exactly is a "routing protocol extension"? I am reading through the HA Technologies section of the ENCOR book and specifically when talking about SSO/NSF, GR, and NSR im seeing that some are being refered to as using routing p...
Just recently installed a C9130 with the EWC. When trying to download the images we are getting a error. I have tried this using TFTP,SFTP and HTTP methods all get the same issue. running config extract wireless profile image-download default
desc...
I've come across this "no ip redirects" command while labbing, this came up while learning how to configure HSRP. The Cisco page on HSRP speciifies this command as part of their config. Iv been doing to research on this and I think I have the basic...
we are refreshing hardware are several locations. Currently I'm looking at a 6504 chassis configured with mls qos lines in the config. These configs do not migrate over to the C9500s that we are putting it. I am not very knowledgeable in this area...
I am wondering if I added to much to my question, i think im really just wanting to know what a "routing protocol extension" is in general, im startinbg to think this is not even specific to SSO/NSF. Thanks for the RFC's though I will bookmark for la...
Issue ResolvedWe have FIPS enabled on the hardware at this location. FIPS had been enabled on the initial configuration put on the controller. We turned FIPS off and now able to join APs.
command returns no results, how can i check the product name? Thanks. Device#show wireless ewc-ap ap image predownload status
Device#Device#show ver
Cisco IOS XE Software, Version 17.03.06
Cisco IOS Software [Amsterdam], C9800-AP Software (C9800-A...
Ok so reading through some of this is appears that older versions did not allow redirects because the redirect package would end up using the actual IP of the active router in the HSRP group. This ends up loosing redundancy because now if that activ...
