Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello , I have a 2801 running c2801-advipservicesk9-mz.123-14.T5.bin - I have a few phones connected to it; doing remote breakout on simple ISDN lines.Is there a way (with this software) to see how many outgoing / incoming calls I have had per num...
Hello, I have a AS5400 - and I would like to configure a VoIP dialpeer with username/pw (pretty much as if the router was a phone)Is this possible ? I have been unsuccessfull in finding information on cisco.com about this, so if anyone could point me...
Hello, I've got a couple of 7940 Series phones setup to a VoIP router (through BRI). It all works fine.I'd like to know how I'd be able (using CLI on router) to see outgoing/incoming call stats pr. day ?Many thanks in advance./mich
Group, I've got a Cisco1760, and when inserting a VWIC-2MFT-G703 to either slot2 or slot3 it is not recognized. What is the minimum IOS version needed ?Or could it be a problem with the router ?Thank you,
Hello,I've got a 7206VXR (with a NPE-300). I am having problems getting the SA-VAM module to work in the router. When inserted, I get the following error:Mar 8 13:05:30.731: %OIR-6-INSCARD: Card inserted in slot 1, interfaces administratively shut do...
Actually the version is irrelevant (as long as the IOS release is > 12.2(4)YB)However, am I correct in asuming that the IPVOICE feature set is required ?/mich
The connected switch obviously work, and is connected to plenty of other devices... the "faulty" swtich, has the following conf:Current configuration:!version 12.0no service padservice timestamps debug uptimeservice timestamps log uptimeno service pa...
Ok - that makes sense. Is there some special debug commands, I could type in that would give you some valuable output ?I tried:'debug ip icmp' - but nothing shows, when I try to ping a host.. /mich
