Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have three questions on DHCP in CUCM 6.1.2.1) We would like to use the CUCM DHCP to hand out addresses for AVAYA IP phones as well. We need to set option 176, can this be done?2) How can I see info on address leases, etc. This funciotnality was ...
Hi, Because CUCM 6 has now got the new feature of local node registration, (ie. if Pub goes down, the EM service on the Sub should take over), I would like to point all HTTP requests from the IP phones to a virtual IOS SLB address and hopefully the S...
Hi I've got IP Phones in 2 different regions, running accross a WAN link. I'm getting the problem that if calls between the 2 regions, that go on for more than a minute or so, then the calls fade out slowly (softer). Now I've heard of this before, bu...
HiI have a problem where I can only dial certain PSTN numbers. Basically I can just phone the PSTN numbers that are directly connected to the PSTN exchange where the IPT E1's terminate.I got two isdn q931 traces (one that worked, and one that doesn't...
Hi, Is there any other feedback on this, I'm running into the same problem.Using MGCP PRI gatewaysUsers have to dial a 0 for an outside line. So to dial a number on the PSTN, they would dial 0083...... But when a call comes in from the PSTN, it shows...
I also just saw that, thanks for the response - weird, I used 12345 and the whole thing just came to life. Is there any documentation on the "why" question?
I use an application that comes installed on CCM. It can be found in the c:\utils directory. From the command line run -> C:\utils\shutdown.exe /RThe /R tells the app to reboot the server instead of a power down. Use the Windows scheduler to schedule...
