Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The network topology that I have is two MSFCs and two external routers at central site and two MSFCs and two external routers at the remote site.DLSW is activated on the external routers. In regards to DLSW+ ER at the central site, only one translati...
If you issue the "clear controller call-counters [all | system-hwm]" this command should clear System's DS0's Active High Water Mark and all individual controller statistics.How could "total Calls since System Bootup" statistics be cleared w/o reboot...
1) What is the use of this ? Is there any config. links for this ?2) Do I need Voice Manager or any other s/w?3) Sometimes the Dial Services appear and some other time they do not.Any ideas?
Accoring to CCO, "The Cisco T1/E1 circuit emulation service modules (CESMs) are designed for use with the MGX™ 8220 edge concentrators, MGX 8230, MGX 8250 and the MGX 8800 series wide-area edge switches. The CESM-8E1 offers E1s for structured and uns...
I can see that this is a quite simple question, but we face the following wired problem. Apologies, if this question is out of this forum scope (any ideas who could help me are more than welcome).Some CAB-T3E3-PL-AD-12 fit into UAI-6E3 properly and a...
Mathias,suppose that there are many ethernet end stations pointing the same single dmac (host).If sb created vlans and he kept the same dmac then he should have to bridge the vlans. With two remote DLSW routers, this would cause a lot of unwanted exp...
Mathias,thank you very much for every single answer and the detailed description that you posted.I have two more questions regarding the DLSW+ ER on the remote branches; I have made a couple of assumptions, because there is only limited information a...
1. This is exactly what I am looking for. The ‘dmac for local clients connecting to the host...’Could the local clients be any remote clients or even clients on the site where host resides?2. In a pure ethernet environment does this make any differen...
