Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Im new on IOS-XR and ASR9K platforms so I need help to understand how to tshoot the led alarms on RSP (for this case critical and Major) running version 5.3.4. I tried to extract information using show alarms brief and admin show alarms but it...
Is there any command with a similar output of show platform hardware fed sw active qos queue stats internal cpu policer for a C6800 (sup 2T) and 4500x ? I understand that this command is for C9000 and ios-xe devices.
I need to check if the CPU is dro...
Is there other command to guarantee that the switch is giving the PoE listed with show power inline interface detail?
Customer has an Aruba AP and they don´t trust the output of the switch because the AP is not booting correctly, and the same AP is b...
I have an issue with a sup C9400-SUP-1XL and I will replace the active one.
The device has two supervisor and i will force a switchover to replace the one that is on slot 3.
The sups are on install mode so my question is the following: Once I put the...
I have an ISR running 16.9.7 version User are having some problems with zoom and teams applications and I noticed the following logs on the router: Sep 10 13:08:49: %IOSXE-6-PLATFORM: R0/0: cpp_cp: QFP:0.0 Thread:002 TS:00000138572425202079 %NAT-6-...
@smilstea Thanks, that helped me a lot.
Most of the alarm are low RX power on SFP and XFP but one is for a failure on a diagnostic of a LC:---------------------CURRENT TIME: PFM TOTAL: 2 EMERGENCY/ALERT(E/A): 1 CRITICAL(CR): 1 ERROR(ER): 0 ----------...
Hi,
I´ve already tested in other port (gi4/0/20) and in both ports the configuration was set to default with cdp disable. Also both ports came up and the output dsiplays that it gave enough PoE.
The AP seems to start but with an error and acording to...
It´s an Aruba AP-515.
Checking on another switch (C3800) that has the same model of AP, the AP consumes 15.4 w.
Here is the output of the other switch with the same AP model connected:
CEF-LM-IDF-TRANSP#show power int Available:240.0(w) Used:74.2(w) ...
