Hi
I have a catalyst 9300 that has inputs errors on non configured and non connected port. do you have any idea of the origin of this problem?
ASW-D-9300-SERVEUR-1#sh int te2/1/7
TenGigabitEthernet2/1/7 is down, line protocol is down (notconnect)
Hardware is Ten Gigabit Ethernet, address is 84eb.ef5e.f7bb (bia 84eb.ef5e.f7bb)
MTU 1500 bytes, BW 10000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Auto-duplex, Auto-speed, link type is auto, media type is unknown
input flow-control is on, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters 00:08:35
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 116988 bytes, 0 no buffer
Received 0 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
78 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
Output 0 broadcasts (0 multicasts)
0 output errors, 0 collisions, 0 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
ASW-D-9300-SERVEUR-1#
ASW-D-9300-SERVEUR-1#sh run int te2/1/7
Building configuration...
Current configuration : 41 bytes
!
interface TenGigabitEthernet2/1/7
end
C9300-48UXM 17.03.05 CAT9K_IOSXE INSTALL
Thanks for your support
Kind regards
Etienne
