Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey,I've bought WRV210 to take care of my home office network - secure my cable connection, setup VPN to my corporate net and provide wifi access for 2 laptops and a few other devices (iphones...)After installing and some initial frustration, reading...
Hello,I'd like to know, is there any way to provide some sort of 'security' as to what ip addresses can register to a particular CCM Express router ? I;m thinking I could create an access list permitting only the specific IP range to access the TFTP ...
Hey folks,A subscriber has an alternative greeting recorder, and uploaded into unity. When callers get forwarded to his VM, they hear the custom greeting followed by the generic unity "you may record your message after the tone..." etc.Is there any w...
Hi everyone,I have the above mentioned kit and trying to get it to work usign leap as the authentication method. Not having much success with it though.I have enabled open authentication, and Network-EAP on the AP a set it to authenticate against the...
Hi,I have a very similar problem anfer upgrading from 3.2.To find out more enable full logging (System Config - Service Control) and see the CSAuth log file under Program Files\CiscoSecure ACS v4.0\CSAuth\Logs... It should give you a more specific re...
Many thanks, that was just what I needed.The only drawback of doing this was that subscribers who are using the system greeting get the beep right after the announcement that the line is busy or does not answer. I decided to modify AvPhGreet019.WAV a...
Hi,I had the same issue, actually using BRI ports for PSTN connect. I opened a TAC case and was told to 'work around' it by either disabling H323 FastStart on enabling MTP. Neither is really a solution, since MTP just chews up too much bandwidth at r...
Hi,There's a known bug that can be associated with what you're describing:CSCec12689Externally found severe defect: Resolved (R) CCM MGCP PRI does not re-establish layer 2 when router reload
Because of the amount of memory available, only one line can take advantage of all available ring tones. Other lines can only use 'small' (simpler) ring tones (I think they should be less than 8k in size...)
