Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've got a really strange problem on an 1841. It is running IOS 12.4(24)T1 and is configured with Fa0/0 in the internal network and two ADSL cards connected to ADSL lines.When I was looking through the logs, the fa0/0 interface logs several "changed ...
I have an 877 that I have configured to retreive its clock from the internal DC. It appears to get the NTP packet but is then somehow unable to apply the data. Here is the debug:187581: *Oct 30 13:48:39.286: NTP: xmit packet to 10.0.0.10:187582: *Oct...
I have configured an 877 for VPN Client access. The Client authenticates and connects and gets an IP address off the IP pool. However, it cannot access anything on the IP network.I've included my router's config. The VPN Client is v5.0.05.0290.Any id...
After configuring a stand-alone 521AP, I am unable to get to configure mode. I can SSH, login and then get to enable mode. However, "configure" is not one of the available options. My list of available options are attached, as is my sanitised config....
I've configured my ASA5505 to allow SMTP out from and into the network. However, when I do a telnet test on port 25 to my relay server, it fails with the following (log traces):7|Sep 04 2009|12:22:20|609002|62.69.62.120||||Teardown local-host outside...
GiuseppeThanks for the note.There aren't any really big issues, but the client occasionally sees this router dropping off the network (they have an SNMP monitor at the central office and this router is the VPN gateway at a remote site), although the ...
I have put in a statement permit esp in. Here is the output of show ip access-list ext-ACL-IN:Extended IP access list ext-ACL-IN 5 permit ip 192.168.201.0 0.0.0.255 192.168.1.0 0.0.0.255 10 deny tcp any any log fragments 20 deny udp any any ...
