Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,
I am after some official Cisco documentation for configuring thresholds for RTT, jitter etc for voice via IP SLA.
It seems to be something difficult to find.
I am not asking if rtt should be less than 300ms or jitter less than 30ms or 40ms.
...
Hi,I have just been through upgrading CUCM, CUC, and UCCX from an 8.5 version to the respective 10.5 and 10.6 (10.6 for uccx version) via 9.1 for CUCM.I only have my publishers at this point as I will be adding subs once I have finished changing all ...
Hi,I am planning a TMS upgrade from 13.1.2 to 14.3.1 in a couple of weeks.One of the new feature is the mandatory https.I am generally not confortable at all with certificates, so if somebody could describe options available to do so, that would be g...
Hi,This is one of our first site where we are implementing Cisco wireless, and we bought some external Autonomous AP1262, when we should have bought Lightweight LAP1262 . We can get those replaced, but I am looking into migrating t...
Hi,I am just wondering if there is an official distance-range for these antennas in ideal conditions (no walls/no ceiling). I have only installed one for teleworking so far, and I am considering using some of these temporary in small warehouses for V...
You will be fine on any 2800 serie with 1 PVDM2-16 and 1 PVDM2-32 http://www.cisco.com/en/US/prod/collateral/routers/ps5854/product_data_sheet0900aecd8016e845_ps5855_Products_Data_Sheet.html
Hi Divine,2800 series do not support PVDM 3:http://www.cisco.com/en/US/prod/collateral/modules/ps3115/data_sheet_c78-553971.htmlPVDM3 modules are not supported on the existing Cisco 2800 and 3800 Series Integrated Services Routers.You need to check ...
Hi,I am afraid you need a new voice card...a T0 in France is basically a BRI, and a T2 is a PRI/E1.You need a BRI 2 port voice card (VIC2-2BRI-????) to replace your VWIC2-1MFT-T1/E1.You will need to change your controller settings on your 2811 (inter...
