Below is the conig for a demonstration Remote Access Server which has PPPoE setup for broadband access via GigabitEthernet0/1 which works fine and a connection into the core network via GigabitEthernet 0/0.We are trying to setup dial in narrowband PP...
Ive got a 2921 configured as a PPPoE server for access into the network over DSL. I want to enable some dial in access. If I add a VIC2-4FXO card to it can it be configured to act as a RAS for dial in access?
I have an 867-VAE on a VDSL line currently configured and working for IPv4. Below is the current config for the Dialer1 interface interface Dialer1 description PPPoE DSL dialler for VDSL line mtu 1492 ip address negotiated no ip redirects no ip unrea...
I have a Cisco switch into which is plugged a Cisco Aironet. Unless the port role is set to access point traffic from wireless clients is 9 times out of 10 not passed through the switch. Why is this, what exacly does port roles change?
To clarify I cant ping 10.3.0.14 from the RAS and I cant ping 10.3.255.254 from the client.Below is the log from the client (a Mac using the built in Mac OS X PPP/dial up software and modem) Modem Reliable Link Established.
Modem Compression Establi...
The switch is an ESW 500 series Small Business Switch, as far as I can tell it only has a web GUI, I cant see any way of getting a CLI on it.The config on the Wifi AP is as follows:version 15.2
no service pad
service timestamps debug datetime msec
se...