Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Allwe have two N56128 and DELL BladeSwitche MXL 10/40I tried to connect the MXL Switch to the Nexus by VPC (2 x 40GBit) via Cisco QSFP-H40G-CU5M cable. N5K----N5K \ / \ / \ / \ / MXL Unfortunately I don't get any...
Hi,is it possible to configure an vmps source interface on catalyst 3550 like ip telnet source-interface Vlan14 for telnetso that the switch use the specified interface for communication with vmps server.Thanks in advanced,Peter
Hi,I have to migrate a ACS Ver3.1 to Ver4.1.But ACS Ver4.1 can only upgrade ACS Ver. 3.3 or higher,so I have to migrate in two steps, Ver3.1 to Ver3.3 and then Ver3.3 to Ver4.1.My problem is now that I have only Ver. 3.1 and Ver4.1Now I need a Ver3.3...
Hi,I have a customer who are distribut the IP addresses via DHCP.It occurs however again and again that a colleague places a new installed server with activ DHCP Serverinto the network, and this new server distributes sporadically addresses.Is it pos...
hi javier,did you find a solution for the problem described above?I have the same problem right now?Thanks in advancePeter Ruestermail [email protected]
