I want to connect a new 4331 router to the network using the mgmt interface (gi0) and configure it using SSH.  I have everything working, but when I SSH to the router, I do not get the CLI.     I have the mgmt interface configured: interface GigabitEthernet0  vrf forwarding Mgmt-intf  ip address 10.x.x.x 255.255.255.0  negotiation auto I have a default route: ip route vrf Mgmt-intf 0.0.0.0 0.0.0.0 10.x.x.x I have all the ssh stuff setup (hostname, domain name, crypto key, ssh version 2).   I configured the transport maps according to the software configuration guide (http://www.cisco.com/c/en/us/td/docs/routers/access/4400/software/configuration/guide/isr4400swcfg/console_port____telnet__and_ssh_handling.html#task_3CDAE22060D641A08A51D1880EEEC080): transport-map type persistent ssh Mgmt-Persistent-SSH  rsa keypair-name mgmt-ssh  transport interface GigabitEthernet0  connection wait allow interruptible transport type persistent ssh input Mgmt-Persistent-SSH   I created the above crypto key (mgmt-ssh).  I have a username with priv level 15 set.  I have the vty lines configured: line vty 0  exec-timeout 60 0  no activation-character  transport preferred ssh  transport input telnet ssh line vty 1 4  exec-timeout 60 0  transport preferred ssh  transport input telnet ssh       With the 'connection wait allow interruptible' command set, I am able to use Ctrl-C to get to the diagnostics mode.  The issue is that after SSH'ing to the router and entering my password, I receive nothing back.  It does not give me the CLI prompt.      The documentation didn't have much troubleshooting info.  What am I missing?           ... View more