Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I am new to Cisco DNA. I recently added a cisco 9300 switch to a network successfully(Managed), however switch did not receive all the configurations such as vlan interface configurations etc. On the DNA Center there is this error ''To...
Hi All,
I have a cisco AP-2802I flashing green and blue, After attaching a console I could see it reboots every 60 seconds with tthe following error. Please note that other APs (Lightweight Access Point) of the same model are working fine with WLC 3...
Hey guys,
I have a DHCP issue on one of the subnets 10.0.1.0/22. IP addresses are released well however only with IP addresses between 10.0.1.1-254 are able to access internet ( browse ) the rest of the users up to 10.0.3.254 cannot browse. tried to ...
Thanks this too would be a solution.I resolved the problem by assigning the switch its edge role (manually), similar to how all other switches are configured in the fabric site.
Thanks BalajiCode is CHHere is the boot log: General initialization - Version: 1.0.0Detected Device ID 6920Master bootloder version 1.34High speed PHY - Version: 2.0BoardId = 0x21board SerDes lanes topology details:| Lane # | Speed| Type |-----------...
