Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just installed a NM-CUE into a 2651XM, configured as per cisco documentation but cant ping the service engine from the router. I have attached my confg plus all relevant show commands. Does it matter which ethernet interface you use?
HiI have just connected a ccme in sweden and all outging calls get fast busy. Incoming work fine.Can someone have a qick look at the debug q931 and sh voice port below. I think its the service provider but want to make sure. (the call below is to lon...
HiI am just about to install a 2651XM-V-CCME in Stockholm (i am from UK) it will use a VWIC-1MFT-E1 for incoming and outgoing calls.I would be very gratefull if anyone can send me a working config for the E1 also any hint tips for this particular cou...
Hi AllI just powered up a new ATA186 with ver 3.0 software already on it. It has an IP address so i can the see web page. When i plug a test phone in i hear a loud buzzing noise and no dial tone, i can hear the IVR when i press the button but still h...
I have a soho 97 router that loses its wan ip address to a BT ADSL line. Shutting down and restarting the dialer fixes the problem so suspect auto negotiation is timing out. Does anyone know how to change "IP Address negotiated" parameters? or any ot...
HiYou were right, as soon as the interface is up it can be pinged. The cisco config examples all show a second ethernet iterface being used instead of the ccme interface so i natrualy followed their examples (the 2651XM is supplied with two interface...
HiI will get someone in the office to plug the fa0/1 into a switch. Problem is the only guy i trust to do this is not back until tomorrow. Will let you know how i get on.Thanks for your helpcolin
Hi fa0/1 shows as FastEthernet0/1 is up, line protocol is down. i tried a shut, and no shut but it didnt come up.the service-engine 1/0 reset, reset the service engine ok but didnt chang the status of fa0/1.and of course the session didnt work.Regard...
