Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've successfully set up four trunks in Cisco Unified Communications Manager (CUCM): two are connected to landlines, one to a 4G gateway, and the last one to an intercom system. Everything is working smoothly so far.However, I'm uncertain about the o...
Hi I have a Yeastar 4G gateway connected to a CUCM setup. I configured a hotline extension, 4040, in the Yeastar "Mobile to IP" route, which corresponds to an extension in the CUCM system. Currently, all incoming calls are being directly forwarded to...
HiI have 3 APs connected to a 9800-CL controller. they are installed in a line along a large hallway. After a reboot everthing works well, clients connect to the nearest AP.After a while clients dont conenct anymore to one clients and after some more...
hiwe are living in a highrise building that is using an old style intercom system. each apartment has a standard 2wire phone connected. to call other apartments or offices, one simply dials for example 318 to get conected with office 8 on floor 31. I...
Hi I am testing CUCM 14. I have a couple of IP Phones 8865 connected to it and use a Yeastar TG200 Trunk. The yeastar has 2 channels. I would like to set it up that every number dialed on the phones starting with 9 should use channel 2 on the yeastar...
hi. thx a lot for the extensive answer, it helped me a lot!the tp seems to be working now for any number being send by the trunk, except when there is no number. as far as I understand, "!" stands for any number /any amount of numbers but with a mini...
the device was defective. I got a new one now which doesnt reboot continiously.Now I am trying to get it configured. The device should provide a SIP gateway for the trunk I set up in CUCM. If CUCM connects a call to the gateway, it should dial out of...
