Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have two Cisco 5508 WLC and SSO is enabled. If i follow the below steps, will it erase the configuration of both WLC's. Please confirm. Thank youlogin to WLC GUI with valid username and password.Go to Command > Reset to Factory Default.Click Reset...
Hi All,We are getting the below error on our Cisco 3560 Switch and the device is running on the image ":c3560-ipservicesk9-mz.122-55.SE4.bin".010790: Mar 2 00:19:35 PDT: %PLATFORM_ENV-1-PWR_RPS: Redundant power supply faulty or in standby mode010791...
Dear All, Can you tell me, is it possible to add one E1 / Module on 2811 Router. Will it support ? Is there any impact due to that? HQ#sh verCisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 12.4(17), RELEASE SOFTWARE (fc1)Techni...
Dear All, Client was asking us to enable the port 55001 and 55002 to run on QOS on the WAN Link. Kindly advise how to configure and enable the port. Thank You. policy-map QOS class SilverAF31-Map set ip dscp af31 police cir percent 50 bc 300 ms pi...
Dear All,We are getting high CPU Utilization in Cisco 2801 router. I just want to know , is there any bug with IOS image ""flash:c2801-advsecurityk9-mz.151-2.T1.bin" and also which process makes the CPU highly utilized. 2801_RTR1#sh processes cpu CPU...
Dear Daniel,Thanks for your reply.Please find the requested o/p for ur info. Thank you2801_RTR1#sh processes cpu sorted CPU utilization for five seconds: 82%/76%; one minute: 86%; five minutes: 83% PID Runtime(ms) Invoked uSecs 5Sec 1Min...
Dear Rick,Thanks for your information.Can u specify the necessary configuration changes under Multilink ? Waiting for your reply. Thank You.Thanks & RegardsSenthil
Dear Ankur Garg,Thanks for your support for this case..I have tried with image "c3750e-ipbasek9npe-mz.150-1.SE.bin"..But it is giving the above error..What i have to do in this case...Please help meRegardsSenthil
Dear Ankur Garg,Thanks for your reply..After successful upgradation of Micro controller, Now it is showing " hardware not supported by firmware .Try loading newer software instead.System resetting.Now what i have to do?
