I have a cisco ASA with connections going outside, inside, and two dmz's. I want to be able to capture traffic from each connection. What would be a good way to do so ?
I just replaced all of our older switches out with newer Gig-port switches. I noticed that the network speed didn't increase like I had hoped for. We have workstations plugged into VOIP phones that have ports only rated for 10/100. Is there anything ...
I have a cisco AIR-RM1252G and it was previously configured for another remote site. I changed the BVI1 ip address and can ping it and connect wirelessly. Clients that connect to the AP do not get an IP address. I can ping the DHCP server from the AP...
We had a trunk link go down on a switch due to the fiber cord being bent. I replaced the cord and wanted to add a redundant link just in case this happens again. When I added the second fiber to trunk link, a loop occured instantly. Once it was unplu...
I cannot get my phones to register with CUCM 11 and I and running an os that has CME 7.0 on my router(lab environment) . I know the guides say to have a current version of CME but in the real production world here, our CUCM is new and our operating s...
Josh,
What happened on my end was..... when I logged on to the ACS I was ignored the Alerts. It was telling me that purging was not being done. Set up your backups and purging , then run a purge, this should fix your issue. If not reset the ACS to r...
Leo,
I just figured out the problem. I set up a lab at home and took a look at my configs. I entered in everything like it was except I left out any security for the SSIDs under the Dot11xradio0... then I went back and added that back in ... and i...