Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am working on a VPN project in which we want to nat entire subnet to another one
I have worked for one-to-one nat in this scenario and following commnand works for that.
ip nat inside source static 192.168.2.196 10.140.68.1 route-map VPN-2-Rem...
Hi , Our partner network using checkpoint which support ikev1 with "group 14" . Our ASA doesnt seem like supporting group 14 , it supports group 14 on ikev2 . Any workaround on this . Please let me know .
Hi , Our partner network using checkpoint which support ikev1 with "group 14" . Our ASA doesnt seem like supporting group 14 , it supports group 14 on ikev2 . Any workaround on this . Please let me know .
We have found strange outbound dialing issues , no impact or response on dialing extension after receiving AA messages . Solved by changing MTP setting on both CUCM and gateway router ( for PRI ) . Steps are shown below . COnfiguring MTP in CUCM---...
Hi , Anyone here successfully setup paging on BE6000 (CUCM ) ?? I have been informed that a third party software "single wire informa cast" need to be installed on VMWare , and will be supported only on version 7.0 and above . Surprised that basic ...
Thanks Richard ,You mean you changed both side to ikeV2 , or you can keep one side ikeV1 and other side ikeV2 . Can you please explain how you did that ?? Claudion
Yes , it will . You can forward FXO to callmanager unity connection . Inside callmanager unity connection forward 3333 to Voice gateway as an SIP connection . Note: Always buy ATA instead of FXS card . Will solve many problem like this automatically ...
