Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After trying twice to upgrade the CUCM subscriber on UCS from 8.0.3 to 8.6.2, we still don't see the new version 8.6.2 on the secondary partition. That is, only one installed version 8.0.3 on the list. Would anyone know the reason why. Thanks.
Not sure anyone else seen this before that after a new installation (fresh install after factory default), couple phones were configured with basic settings (line ext. users, etc.). All phones were in function that could call each other. However the ...
One of the most uncomfortable experience is to apply config changes to UC320, since the action will trigger the UC320 to reboot and cause downtime. I assume this is because the UC320 is up running on XML config file, and requires to reload from updat...
I have a hard time to understand the theory to configure the backplane interfaces on CMM-6T1 and SUP32. Here is the picture looks like:- Sup32 is in slot 5 of 6509- CMM-6T1 is in slot 1 of the same 6509- Saw the output when show cdp nei on sup32: G1...
We didn't see any errors or warning at the whole time during the upgrade. And we did see it says the upgrade was successful at the end of upgrade. PUB was completely fine, using the same COP and upgrade .iso files. Would this be a potential VM issue,...
First off, this bug is an internal Cisco bug talking about if you configure the secondary IP address on the main interface, you would see the error code 87.So far, Secondary IP is the only reason being documented internally by Cisco. However, without...
Just be curious how did you trigger the console mode when using RDP. Did you click the "Remote Control" button while highlighting the Console icon in the TSM window OR you use the command MSTSC /console? I want to ensure there is no other way to do s...
You might need to check the following items:1) Make sure Conference Bridge Software has correct Device Pool assigned. It will affect which phone can initialize the conference. This is important, and I have been working on couple meet-me issues with t...
The equivalent commands for l2l VPN in 7.0 are:tunnel-group type ipsec-l2ltunnel-group ipsec-attributes pre-shared-key Check http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_70/config/site2sit.htm#wp1042423
