Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey all,I have a 2801 router servicing a small LAN (about 13 phones), all working perfectly. I now have to add another phone to the system, but this one a slightly more complex. It is installed at a user’s home. They currently have Comcast high-speed...
Hey all,I have a 2801 (12.3.11(XL1)) running CME 3.2.2 with 2 VIC2-FXO cards. I have dial-peers configured for all the ports and everything works great. However, now I have set a user's extension directly to a dial-peer which of course goes to a cert...
Hey all,I'm new to VOIP here, and our company has decided to break into the VOIP market and eventually become certified. We have purchased a 2801 with CCME and CUE, and about 13 phones. I have installed a FXO card (VIC2-4FXO) into the router and woul...
We currently have a NEC ASPIRE keys system that runs our office phone system. The system connected through a telephone network interface to a Adtran that channels our T1 for voice and data. We are currently working with Cisco to replace this system w...
I have a Pix 515E with an Unrestricted license and I have completed the basic commands to enable SSH support.However, when I try to connect (with SecureCRT) to the firewall, I receive the error "The server does not support cipher 3DES. The server sup...
Ok, since you don't want to break other traffic on 25, you can create a user defined port map and attach that to the inspect rule. Take a look at my second link in my original post at "user defined port mapping". You can create another inspect rule, ...
I believe your issue is that the IOS CBAC has a default SMTP entry of port 25. You need to tell the IOS that there is a different port. Try the following from CONFIG mode:"ip port-map smtp port 587"Please see the following for more info:http://www.ci...
Justin,Have you set a value for time-zone under the Telephony Services in the IOS? After you change that value, you need to re-generate your cnf files with a "create cnf" command.--Luke
Were you able to get this resolved? I have a 2801 which I have installed two PVDM2 cards, but can't seem to locate the right infomation to configure them in CME4.Any help would be appricated.Thanks,Luke
