Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hallo
Is it possible to use CISCO WLC / ISE for following. I've One SSID and 4 Use-Cases.
1. Guest Portal for selfsign in without approval for guests. short time up to 6h
2. Guest Portal for selfsigin with approval for "Longterm" guests
3. BYOD port...
Hi,
I've tried to activate MAC-SEC on a Link between ISR4431 and C3850 or C9500. Now I should enable License hseck9 for enable this function. Any Idea what else would be required ?
Interface:
mka policy p1 mka pre-shared-key key-chain k1
!
IOS: ...
Hello,
Im am currently testing the new features of IOS 150-2.SE5 with SmartInstall
Is there a way to bring the IP SSH Key in the backup-config that after restoring the SSH Key is in the Switch ?
I've seen a "kron" in a forum but it was not working...
Hi
I've a problem at a customer.The customer has Router in Romania. He has 2 connectivity. One Internet connection and one "Carrier line for Voice (Lync,Business Skype) Traffic only".The Problem we have is following. On the Router 1941 we want to m...
Hi I have one Main location and 2 destination. I want to have 2 GRE tunnels one to each destination.The Problem is, that one tunnel in the Main location does not come up. (up/down).I've a Cisco CAT6500 at the Main location with 12.2(33)SXI4a.When I c...
Many thanks, I'll try this when i happens next time. "But hope" we will fix this problem prior.. it should be renewed automatically before it expires.
It works with all Switches only the WLC98X is causing this issue.
Hi Greg, I've the same issue but with cisco WLC 9800. With Trustsec enabled. And I've no change to login from GUI/CLI/Console after PAC is expired. The only thing that helps is reload the WLC.. Then it is fine for 3 Mt. Do you have any idea what coul...
Hi all,
I got now the solution from TAC:
I'm using WS-C2960CG-8TC-L andWS-C3560CG-8PC-S Switches
CONFIG:
VSTACK-DIRECTORconf t no vstack script flash:post_install.txt! vstack group custom NR32 connectivity no script flash:post_install.txt--> Be sure...
Hi leo
i am not using a config template, it is the file from backup. I use smart install for a replacement solution in a running network.
the switches perform an backup with a kron job every sunday night.. And if one fails the customer can replace th...
