About UrbanPeasant

UrbanPeasant · 06-24-2022

I need to match several explicit numbers on an incoming (from PSTN) dial peer so i can send the calls onwards out of a specific trunk, and I'm not seeing how I can do that, as the options I've used end up catching calls for other combinations of numb...

UrbanPeasant · 11-25-2021

I'm struggling to understand why the From in our outbound INVITE to our primary ITSP is using the IP address of our secondary ITSP, instead of the IP address of our CUBEs sending interface. INVITE from Jabber to CUBE is fine:Received:INVITE sip:80781...

UrbanPeasant · 09-16-2021

Hello,We're in a process of transition and moving all staff to a new number range and new PBX. This requires being able to dial the new numbers directly from the PSTN via our existing CUBES, and redirecting calls placed to our old numbers to those ne...

UrbanPeasant · 06-17-2021

I've hit a problem where we are able to get UDP 5060 SIP calls out to the PSTN via a CSR1000v (IOS17.3.3) across a primary ISP connection to one of our ITSP SBC end points, but we are not able to get calls out from a CSR3925 (IOS 15.7.3) across a bac...

UrbanPeasant · 06-04-2021

I have 3 CUBE ISR3925 gateways in production and a new virtual CUBE CSR1000V that's ready for testing. They trunk to CUCM 12.5.1 and currently using Jabber 12.9.3.I need to send Jabber calls to a specific phone number out via the new vCUBE for the sa...

UrbanPeasant · 06-27-2022

Thanks all, I appreciate the help.It's SIP.The leave the incoming peer that collects the call from the PSTN trunk alone. This ITSP = this dial peer. It seems to work well there is a single peer collecting the calls.The incoming call is matched on inc...

UrbanPeasant · 06-24-2022

this sounds like a great idea. Looking into it.

UrbanPeasant · 12-17-2021

The 'problem' here turned out to be the following:Previously we've had 4 ISRs connecting to 4 end points at 2 ITSPs. One of the ITSPs required almost no config on our part, and no registration - this was our primary and holder of our number ranges.Th...

UrbanPeasant · 12-01-2021

I thought a ladder diagram would perhaps be useful in trying to understand where this is going odd (same call as above, but with fresh debugs attached - lots of ccapi errors because there's a call transfer that's stuck open and the call clear command...

UrbanPeasant · 11-26-2021

Hi Roger,Thanks for posting back. In order to write something understandable I've slowed myself down and picked-over what's going on again.From the CUBE perspective all incoming traffic from CUCM is picked up on Dpeer 190, and sent to the PSTN (prima...

Member Since	‎07-21-2015 03:15 AM
Date Last Visited	‎08-06-2022 02:20 PM
Posts	65
Total Helpful Votes Received	45

User Statistics

User Activity

How do I match several explicit incoming numbers in one string?

Something odd about our From SIP Header

Redirect old numbers to new numbers on a new PBX

SIP Packet Size at Fault?

Need to make Jabber (CSF) calls route via a specific CUBE gateway, but route patterns are ignored.

Re: How do I match several explicit incoming numbers in one string?

Re: How do I match several explicit incoming numbers in one string?

Re: Something odd about our From SIP Header

Re: Something odd about our From SIP Header

Re: Something odd about our From SIP Header