Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,
I have above switch N9K-C9236C and my end NIC card has 200GB card i want to do the connectivity between Switch to server to using splitter cable 2port 100Gb + 100GB switch side and next hope will be my NIC it has 200GB
So which QSFP Module a...
Hi Team,
I have 3 WAP and 500 Mbps leased line I get 500 MBPS speed on LAN but on WIFI user gate 50 to 80 MBPS internet Speed.
one SSID for the 2.4 & 5G 2.4 channel Automatic i change to 1,6,11 but no progress FM version is 10.5.2.0
Can some one gui...
Dear Team,
Please guide how to configure below type of configuration.
How to set vlan under the interface after stack configuration and what will be configuration on CBS-48T switches.
Please guide.
Hi Team,
How to find out Cisco Wireless Access Points series which work without controller means is in standalone mode.
If any link or suggestion please guide to me.
Thanks & Regards,
Sachin Chopade
Sir, Sorry Its mistake the NIC is 200GBPS speed can i use 100GB X 100GB Splitter cable in switch side, (Switch has 100GB per port can i use both port through splitter cable,Please see the attached diagram if it will be possible please suggest requi...
Hi SIR,
END device wireless card QUALCOMM ATHEROS QCA9377,Yesterday I checked single AP but laptop speed will be 220 on 5Ghz and LAN speed 441 any limitation in access point as per observation speed not get more than 230
HI Team,
I have 3 AP Connected through CAT6 cable its working but speed get very slow i have 500 mbps leased line any additional configuration required in the GUI RF optimization and etc please guide ... but on LAN i get 480 -500 MBPS
Sir, yes i will do the Port channel on copper interface caused its no of 8 access switches. do you any reference link and documents for the configuration, also core switches is in HA mode ..
