Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiCan you confirm that i can have 100 users across 5 sites with a UC560 - this looks ok from the datasheets. There must be 2 attendant consoles for operator usage.Therefore I'm ordering the following:1 x SW-UCC-CME=1 x SW-UCC-SERVER 2 x L-SW-UCC-OPER...
Hi I have a customer with CUCM 7.1(5) using encryption including MGCP gateways. Currently seperate standalone fax solution.They want to move the faxing (rightfax) into CUCM.Is T.38 fax relay supported with MGCP so call flow would beIncoming call to g...
Hi allHas anyone else come across this? An outbound call to an invalid number across a SIP trunk returns ringing rather than number unobtainable.Gateway is configured in Callmanager as a SIP trunk, config is simple and provided by the line provider w...
Hi allAre there any issues with this? I've not managed to find a link that states it's ok or not but I have found a couple of forum discussions where CR has been disabled to get things working....ThanksAndy
Hi allI'm not sure if this is possible but I'm looking to manipulate incoming calling party before forwarding a call on to a sip trunk.Scenario:CUCM4 <----ICT----> CUCM8<----SIP---->SIP End deviceI have no control over the CUCM4 or the SIP end device...
