Brandon Rebbe
Beginner
Beginner
Member since ‎07-18-2012
‎09-14-2021

User Statistics

  • 66 Posts
  • 3 Solutions
  • 30 Helpful votes Given
  • 10 Helpful votes Received
Recent Badges
10 Helpful Vote
CCP Member
1 Helpful Vote
1 Accepted Solution
20 Replies
10 Replies
5 Replies

User Activity

We have a local PSTN gateway for Webex call with an ISDN PRI connected.  Incoming calls work great and are routed to Webex Call. But when i try to dial out from a phone i get an error. Looked at the Q.931 and it is showing invalid elements and it loo...
I have an older ATA 191 that i am trying to get Multiplatform Firmware loaded too. The existing Web UI does not have the options under the administration area to send the command to update from a local TFTP. I also found a couple deployment guides th...
I have an ISR4321 with Cube licenses and i already have it registered to my Webex Calling Location and online. The examples for Dial peers in the deployment guide refence sending the calls via IP to another service or gateway from the ISR Cube.  Our ...
The RoomReady controller connects to the codec via SSH and polls the codec 1 time every 60 seconds. What is the suggested polling time? The RoomReady controller is connected to 500+ codecs around the world and the only time this issue is seen is when...
Hello  I have CUCM 11.5su3 with Expressway C and E setup on 8.10.2   Secure Traversal works between the the C & E, TLS enablesNon-Secure Neighbor Zone from CUCM to Expressway CAll CA singed cert from the E to CUCM.   B2B calls are working and our Web...
Community Statistics
Member Since ‎07-18-2012 07:26 PM
Date Last Visited ‎09-14-2021 08:48 AM
Posts 66
Total Helpful Votes Received 10
Helpful Votes From