Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm running VPN between two sites using 2 ASA 5505.Also I want that RA-VPN which is hosted in both ASA.My need is to remove one of the RA-VPN access and keep only one, but need to be able to reach the second site.I did a split-tunnel with both LA...
Hi,I want that some one confirm for me if I have an Express AP 521 that I can change it to operate as a LAP and vis versa?That's I have only LAP available and I don't know if an Express Controller is required of I can change them.Best Regards,Omar
I have an old PIX 501 with PIX OS 6.3 Is that any limitation when statically translate UDP ports, right now I'm doing IP-to-IP NAT but only some ports are opened. Any suggestions? Regards, Omar
Hello,I'm using a Cisco 1720 with 12.2(2) IOSAnd the following command on the subinterface give an error:encapsulation dot1q 1Encapsulation command is available but with no parameters and it's not accepted alone.Is there any way to so that?Regards,Om...
Jonathan,This is a very old router, and is not even supported by Cisco.Try the commends described above. If it will not work (that I'm not sure if the commands are supported) you'll be required to use a new one.I would recommend that you use a new Ci...
OK.I think that it's not a switch problem.Let's back to the ASA:As you mentioned, when you connect the IP phone to a default ASA port (Vlan 1) if works without problem.And now you're connecting it on a Vlan400 port.Can you please provide the related ...
