Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone ,i have an issue and i hope to help me , we have cucm and IP phones in the network and we are using extension ID range 100-160 and 1000 - 1050, when the speaker is on and trying to call extension 1000 once i type 100 and before type the...
Hi Everyone ,i have PPPOE server which is configured in Cisco router 3800 and Radius server , everything is working fine but the issue is when the user is disconnected from the PPPOE server the user remain stucking in radius server and the user will...
Hi everyone ,
I have router 6509 , it's working as BGP router. the upload goes through the main provider but i have a certain network which i want to route it's upload to another provider so i created a route-map role but when i apply the role, the C...
Hi Everyone,
Can i by using EEM (Embedded Event Manger) to monitor my interface traffic?
just to Clarification my question:
let's say if the traffic on interface gigabitEthernett0/0 less than 20Mbps the EEM will take an action.
thanks in advance.
Hi everyone..
i have a (Cisco router and 50 PCs), i wanna to configure a pppoe server on my router and create users in pppoe server for my PCs.
can anyone help me how to configure pppoe server and how create the users to the PCs?
Dear Georg ,when i issue this command (clear pppoe all ) all users will disconnect from PPPOE server, but when i am checking the radius server i find all the users are still connecting ,it's just like the PPPOE server not updating the radius server ...
