I have a firewall with 2 defa routes with the same weight (2 diff isps). When I change the weight of one of them to a higher one, the dns stuff check mail facility doesnt find the address (both addresses are published). When both have the same weight...
If I decide to change the operating vtp mode in a switch, let's say from server to transparent mode; do I lose the VLANs configuration, I mean, the vlans created in the old vtp mode get erased..?
First question:How can I redirect the debug output to a vty line instead of the console line...Is there any command..??Other one:What is a reason for getting an async interface reset..?...%LINK-5-CHANGED: Interface Async52, changed state to reset
The 6:1 or 8:1 relationship means that 6 or 8 Gigabit ports share a 1 Gb connection to the backplane of a 4006 or 450x switch (in my case it applies to a 48 port line card). But, can I change the defaults of flowcontrol..?...I mean, Is it possible to...
Hi all, I have a 4503 and some 4006s with WS-X4548-GB-RJ45 modules. I these switches I have servers connected via 1000BaseTX to the modules. The problem is that when I make backups (Gigas of info), the delay it takes is worrying and frustrating (it ...
Harold, in effect I found a way to make PBR inside the firewall and left both static routes with the same weight. Everything worked. The purpose of the second route in regard to the mail application was (in fact is) that both routes are used to publi...
But in which manner is the routing loop creating itself..?...See, I change the weight to have preference over the higher route, I mean, I leave the higher weight one as the floating static route this way:ip route 0.0.0.0 0.0.0.0 x.x.x.xip route 0.0.0...
Try configuring one native vlan on the trunk port. You can then connect the host and it will be able to communicate (as soon it belongs to that native vlan)..hope that helps
Right, I understand the 6:1 or 8:1 relationship in my case. But, can I change the defaults of flowcontrol..?...I mean, Is it possible to change flowcontrol send on and flowcontrol receive desired (default for blocking ports) and convert in a 1:1 mapp...
It is possible that this model has a similar behavior to that of the 4xxx series, in which the cpu has other higher priority tasks to worry about (switching, vtp, dtp, etc), and the ping is a low priority task, and that's the reason of the high respo...
