Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 1841 with IOS c1841-ipbase-mz.123-8.T7.bin,when I do a trace to an address that is not in the table it reply in the first hubMS1RTR01#traceProtocol [ip]:Target IP address: 198.133.219.25Source address:Numeric display [n]:Timeout in seconds [...
I have a Cisco 3005 and our users are using Cisco VPN client, however I have one user who has a DSL over ISDN alcatel router at home and this device is assingning address in the same network that our DHCP server so the user can connect to the VPN bu...
I have a 3745 I installed a VWIC T1 card and I have one T1 connected in each, I have four PVCs in the First one and one in the second one, I am running EIGRP process 1, In the First Serial Interface I am able to see four EIGRP Neighbors however in th...
I have a wireless network with AP 1200 and Clients computers with 350 Series PCMCI Wireless LAN Adaptors and everything is working fine, now I have added a new building with CISCO AP 1300 with the same SSID and the same WEP some laptops wiht another ...
I have heard that you can configure a "menu" in a 2600 Router (used as a terminal server), the thing is like this: you telnet the Terminal server and the equipment display a menu and then with a selection in the menu you connect to one of the termina...
The weird thing is that when you trace from a PC that has the router as DG it goes to the internet, however the PC shows the firewall as first hub and not the router (the router must be sending ICMP redirects)H:\>tracert www.cisco.com -dTracing route...
I beleive that I have found the problem, the problem is that I am using secondary IP address in the remote router and Eigrp just work with primary addressRegards
