Hi experts.
I have AP's connecting to a centralised 5520 controller. The controller on the wired side access VLANs 900 and 110 for the relevant SSID's. Hence we have:
vlan 900 = SSID A
vlan 110 = SSID B
Our switches network is configured as VTP t...
Hello experts.
I am trying to connect a Catalyst 3850 to Nexus 9K.
In the main this has been successful, unfortunately whilst the 9K sees the CDP neighbour fine, and can ping the 3850 switch management address I am unable to ping the 3850 from ot...
Hi all.
I'll try to keep this simple.
Using a 5508 WLC with HA, and 2702i AP's I am trying to configure a flexconnect AP to be used on a site which whilst it has routing back to us we do not manage.
This means I have no control over the VLANs o...
Hi experts.
We use a Cisco ASA 5515 configured to provide a webvpn aka portal service to an application we use internally.
We are finding remote users can connect and authenticate fine to the application via our portal, however when they try to p...
We have ACS 5.5 in production which works well for our internal users.
We now have a requirement for eduroam / govroam (both work in a similar manner).
My challenge is that I only want users from a particular wireless SSID to be authenticated on ...
Thanks Reza.
Yes the 3850 has the default gateway configured. If I connect the 3850 to another device I can ping and manage the switch etc. The problem occurs when I connect the 3850 switch to the Nexus 9K, so I believe I've missed a command, just no...
Thanks for responding.
The management interface of the 3850 switch is in VLAN 999
On the 9K I have:
interface Vlan1 no ip redirects no ipv6 redirects
interface Vlan966 description L3-transit-to-Core no shutdown no ip redirects ip addres...
Thanks very much.
I have connected the AP to the WLC locally so it has found it, the routing allows the AP to see the same IP address, aka not a NAT when out at the local site.
My concern is mainly down to the vlan and getting it working!.
Many...
Thanks very much.
I now have the wireless controller configured.
I've been googling for a good guide on how to configure ACS 5.5 so for a given SSID ACS forwards the authentication to an external
server.
I must confess I am finding this elemen...