Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been trying to find the right information on Cisco's site, and I'm not having success.We have a 3900 router that we would like to do authentication via a local userdatabase. We want ssh access and console access using a local user on the router...
When logging into the web interface for some of our access points, I am noticing that the configured radio channel is different than the active radio channel. Can anyone tell me what the difference between these two values is?We are running 1141AP's...
Hi,This is our current wireless configuration. Our stand-alone AP's (1140 and older 1100's) are using Windows RADIUS authentication with WPA2/AES. We would like to broadcast the SSID for our wireless since currently we are not.I have enabled the "S...
We have an autonomous wireless network that is using WPA/TKIP, and authenticating back to a Windows 2003 IAS Server. We are going to be adding wireless to other offices, and are looking at implementing WDS. I have found documenation on Cisco's site...
I am looking for assistance and cannot find documentation on what we are trying to accomplish.Our current wireless network has autonoumous access points using WPA, PEAP MS-CHAPV2. Our access points authenticate back to a Windows Server 2003 IAS serv...
I understand. What is strange is I have the same issue on another AP at another location. I updated the IOS to the latest release, and on that AP, the problem went away.I'm going to try to disable the radios at the other AP's, and see if that makes...
Hi Surendra,This is what is happening. I am logging into the web interface, and I select the wireless radio from the home screen. From there, that takes me to Network Interfaces\Radio0-802.11N. On this page there are four tabs, the radio status, d...
We are having a similar issue. We have an ASA5505 and on this network we have a scanner/copier that does scan to email. We are noticing that when the copier/scanner attempts to contact an email server that resides on the other side of the tunnel, w...
Thanks for your help. I guess leveraging our existing configuration isn't going to work then. I'll have to re-read some of the documentation since it seems like from Figure 12-4 in the attached link made it look like our current configuration would...
