Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i have an SRW2024 here which is not working like it should be.I am not able to configure the IP Adress so that it could be used. I can configure the IP using the console, but it cannot be access or pinged from an attached device.Also the switch it...
Hello all, I have the following situation. I have 2 locations connected as described in the attached image, via a 2Mbps leased line. Both routers are connected each to a switch (non-cisco at the moment) and I have a server attached to those switches,...
Hello all, We have a Cisco VPN 3005 concentrator at our HQ. I have a group configured which uses NT domain authentication and it works fine. The problem is, as long as the user has a domain account, anybody can connect. Is there a way to restrict ac...
Hello all, This may sound like a dumb question. We need to set up a new VPN connection to a customer and they have an IPSEC capable router with only 1 network interface. It has a private IP, the router is placed in a DMZ. Is it possible to terminate ...
Hello all, I have a problem using rate-limiting on a Cisco 831 (IOS 12.3(8)T11). We have the following situation. There is an IPSEC tunnel from the 831 to an external company. Within this we have a GRE tunnel for multicast traffic. One of our develo...
no, i did try everything, but when i configure another VLAN, i get the message, that only a valid VLAN coudl be configured.Which should be right, as this switch was right out of the box and nothing could be configured except the settings in the conso...
Just wanted to follow up on this. The problem was finally solved. Here is the config that i have now on both routers:bridge irbinterface Ethernet0/0 no ip address half-duplex bridge-group 1!interface Serial0/0 bandwidth 2048 bridge-group 1interface B...
Some follow up on this issue. On both routers, I put the ethernet and serial interfaces in the same bridge group and I believe the bridging works fine now. If I do debugging on STP, I see topologies changes, events and so on. However, nothing else wo...
Thank you for the link. So basically I create a BVI interface and assign the Serial0/0 to the bridge group. Then create dot1q ethernet subinterfaces for the trunking to the switches. Does that make sense? Could you possibly post a sample configuratio...
I just want to point out a problem that I had with the BVI configuration. I used to have the same situation, one router with 2 network interfaces connected to a pair of switches. I had the BVI interface up and everything seemed to work fine. However,...
