Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have configured a 2801 as a DHCP server, but every IP that is taken by a host is not released when the host is turn off. Therefore I have to reboot my router in order to have free space in the DHCP scope.I do not know if I have to use more optio...
Hello,I need to recover a 2948G L2 switch. It is in a loop with this message:WS-C2948G bootrom version 5.4(1), built on 2000.04.04 10:48:54H/W Revisions: Fin: 2 Head: 6 Board: 1Supervisor MAC addresses: 00:05:01:2e:c8:00 through 00:05:01:2e:...
Hi, I am installing a NAT-PT router translator to join ipv4 and ipv6 networks. I keep getting this error message:*Feb 21 14:00:36.959: IPv6 NAT:v4tov6 entry not found Here is the running config of the NAT-PT, I`ve used all my cards and I can`t figu...
Hello, I have 2 routers 1800 series with switch modules incorporated connected with IPv6. Everything is working fine except for the problem that when I assign an IPv6 address to a Vlan (using the EUI-64 format to the switch ports), it assigns the SAM...
Hi,Thank you for your help. I have used this link for configuring this feature and It didn´t work OK.Do you have another link with diagram or topologies?.Regards.
Thanks for the reply, but I just solved the problem. The problem was with the command IPV6 ADDRESS AUTOCONFIGURATION. This command definitely brings up a lot of trouble with VLAN ipv6 address assignation.After some testing I concluded that:1- If one ...
Hello,Thank you for your answer. In your opinion, can we use VLANs (4 802.1q VLANs on Advanced IP Services IOS image) instead of a physical interface with the 4-port 10/100 Mbps Managed Switch?
I have resolved my problem. I was installing CW2K under Windows 2000 Professional with Service Pack 3, as quick start said(http://www.cisco.com/en/US/products/sw/cscowork/ps2425/products_quick_start09186a008017b359.html#wp66625)I have uninstalled thi...
I did what you said and also I have reinstalled CW2K LMS 2.2 without Netscout nGenius. Everything is still OK, but again About ANI Server--> Device Support Error Received and all appear as UnknownProcess Status ANI Server: Runnin with busy flag...
