Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I would like to know if we can replace the sockets in one of the power unit of C6509E(which has a redundant power supply) online.Should I have to power down the chassis to replace the sockets in both the power units of C6509E?Any document...
Hi AllI would like to check whether my NAT config is going to work good.Also I'm not not sure if this config is Source NAT (or) Destination NAT.If someone can shed some light on this that will be appreciated.Hope my explanation below will be good ...
Hi All,I would like to configure both radius & tacacs authentications on Cisco 7600 router.Is it possible? Can anyone give me some tips or refer to some urls?Thanks,Beno
Hi All,I am looking for a cisco config backup software which can track the config changes and save the configs while I do the changes.I guess CiscoNetflow can suit my requirement.But are there any other cisco specific softwares?Can someone let me kno...
Hi all,I need to associate the serverfarm(VPNFARM) that I have created to a physical interface say (Gig 1/14)?"ip slb serverfarm VPNFARM"I'm not sure If this is possible with Cat6500's?Can someone help me out with the commands?Many ThanksBeno
Hi Jorge,Thanks for your comments.My config is working fine.But I should have explained a bit more of the network topology.ROUTER--->FIREWALLRouter doing NAT is connected to a firewall which has 2 ports for these networks and in separate Vlans:10.84...
Hi Andrew,If you have used both at the same time-Radius/TACACS,then which username/password will you key in when the router prompts for the login?I guess you can either use Radius (or) TACACSIf it still works for you then let me know the config pleas...
