Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi guyslet s imagine we have a central site with two or three vpn 3000 concentrator in parallel mode to achieve load balancing for remote connection such VPN client 3002 that happens correctly, my question why we can not achieve load balancing for o...
hi guysi ve read somewhere that when all options (NAT-T TCP UDP)are enabled for transporting IPSEC traffic especialy when dealing with PAT, the one that take precedence is the IPSEC/TCP,however when doing some assessements I find out that the answer ...
hi guysany idea about how could i access a VPN concentrator management GUI, without having any access to any VPN 3000 series.i mean , am looking for simulation software as the one made for SDM.thanks in advance.
hi guys when dealing with modular policy on an appliance especialy at the stage where we are trying to configure IPS [ ISP (inline/promiscuous..) (fail-open/fail-closed)] is a modular-hardware (IPS CARD)is required or the IOS/PIX can do the job alone...
hi-QOS quality of service is a paradigm , a set of rules to prioritize packet..-COS is class of services ,values are from 0..7 deal with the Layer 2.-some operating systems allow you to change the value of the TOS(type of services) of your packets .(...
hithere is a command that can be bad as it can be good no ip inspect name protocol(for a specific protocol), or just no ip inspect name (for the rule), this command will clear all the sessions, it will remove all the dynamic ACL created by the inspe...
hiby default eigrp is a classfull routing protocol, so you dont need to type auto-summary it s there by default, since under your router eigrp 100 you configured the network 10... the router will run eigrp on all interface in the 10. network so the r...
hishape works only in output direction however police work in both directions.if you are in FRelay envirenment i thinks you have to enable : frame-relay traffic-shaping for the interface .HTHdo rate if it does help
