Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I think I a missing a step to get this working, but I cannot seem to put my finger on it.I have a 7965G with a 7916-24 addon module. CME version 12.3. IOS-XE 16.9.8The module powers up and goes to a black screen / screen off.The status menu in...
Hello,I have a 4331-V/K9 that I would like to use for an IP phone system. It currently has IOS-XE 16.3 installed and has a permanent UC license. I see that the SWSS licensing is EOS and that flex is the only option:https://www.cisco.com/c/en/us/pro...
Hello,I have a lot clients that show many 28 min 48 sec association duration. Is this a problem with the wireless network or client drivers? It's happening with more than one brand of wireless card and different brand of computers.WCS and 5508 WLC ...
Hello,Does anyone have a 5508 controller with 1142's setup in H-Reap mode with wpa2/aes/psk authentication?No matter what configuration i try I cannot get a client connected if the access point is communicating with the controller. As soon as I disa...
Hello,I'm seeing a high number of output drops when we are running backups from site to site over a wireless bridge. Our setup is a follows:backup server - 3560G - 3560 - 70mbit wireless bridge - 3560G - sanWhen the backups are running and sending d...
3560x for the POE on the phone and the power supply to power the module. The phone works fine, and the module turns on just fine, but after it boots it goes to a black screen because its not configured on the phone.
Ah yes. It is set to 1800 seconds.The documentation says:Set the maximum time, in seconds, for a client session before requiring reauthorization.The default values are for the following Layer 2 security types: * 1800-802.1X; Static WEP+802.1X; WP...
