I set up an 829 in my car and tried to connect the Ignition Control port to my cigarette lighter port.
It seemed to work for a while but eventually it stopped and my fuse for that outlet is blown.
Now i would like to know what the expecte...
i'm working on integrating Control Center into GMM and get this error: "URL is invalid".
Below is the error message and my setup.
Any idea which URL is wrong and what the URL should look like?
Welcome IoT enthusiast!
This Community is for you (Customer / Partners / Cisco Employees) to ask and answer technical questions about Cisco Kinetic.
Everybody (incl. Cisco Employees) is encouraged to ask questions and everybody (incl. Customers & P...
The base model has one SFP/RJ45 combo port, 4 FE LAN interfaces and one slot for LTE.
You can use these interfaces at the same time for dual WAN.
But you are restricted to the interfaces available, examples:
- LTE + SFP/RJ45 (routed inter...
I haven't used this system yet myself but there is an integrated help menu.
I would recommend you try to answer your question.
If it can't help you, ask the question in the forum I posted above.
Good luck with your training!
I assume you are doing this course?
I recommend you reach out to the general Cisco Security community and include your course link and ideally a NetAcad label (i...
would you mind posting this question in the general routing community?
This forum here is for IoT specific questions and your problem sounds like standa...
the guest shell is not supported on the IR1101.
It is an entirely different architecture compared to the IR8x9s.
However, we are working on creating similar functionality with the help of an IOx app.
We are currently looking for EFT cus...