Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,I have a router with two adsl connection, one of them is working fine. The another one I cannot see any packet going to the ISP. The interface atm is up, there is no reset, error, etc but the router doesn't try to connect to ISP, I see this w...
Hi Guys,I have a UC520 with 2 ISDN BRI interfaces. One of them is connected to telephone provider and is working fine. Another one is connected to a server with a ISDN card. My issue is with the last one, I cannot make the ISDN interface up/up when I...
Hi Folks,I'm new in EEM and I'm trying to read a interface counter and save the value in a new variable. I will use the new variable to manipulate the value.Should I use SNMP (event snmp oid ...) to get the value? RegardsPadula
Hi,I need help to understand how snmp monitoring works when we have WLC in the networking.Before the WLC 5508 instalation, we had the Nagios monitoring each Access Point in the networking. Today, the Nagios still monitoring the networking, but the Na...
Hi Vasilii,Thank you for your reply. Actually the IOS was the issue, that one that I was using doesn't support the configs that I need. After the upgrade it started to work straightaway. Tks
Hi m.batts, You were right, it has to be a cross cable. It didn't work with the straight cable. Tks for your help. But the ISDN card on UC520 doesn't support a NT role, we had to buy a VIC2-2BRI-NT/TE and type the command "line power", after that, th...
Hi Carlo, But the UC520 is doing the "tephone provider" hole. So, I suppose that the UC520 is the Network side and the server is the client side. Does it make sense? TksDan
