Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi community,
I have to implement in my company the Dot1x for the wired.
As supplicant we use Anyconnect software, as authenticator WS-C3560-24PS with IPservices 12.2(58)SE2 and as authentication server Cisco ISE v.2.3.
- - - - - - - -
The scenario i...
Hello people,
I had a problem with WS-C4506-E last Saturday.
There are these logs:
%VSLP-3-VSLP_LMP_FAIL_REASON: Te1/1/1: Link downFeb 25 21:24:47.515: %VSLP-2-VSL_DOWN: All VSL links went down while switch is in ACTIVE roleFeb 25 21:24:47.515: %EC...
Hello,
Yesterday I had a problem with the AP AIR-CAP3602I-E-K9.
The AP is connected with a WLC 5508.
The disservice has been for few seconds.
The logs are these:
1 14:40:00.675: %DOT11-6-ASSOC: Interface Dot11Radio1, Station 4c66.419b.cb74 REAP Asso...
Hello people,
I'm having a problem with the HTTP access on C3560CX.
My customer has connected the new switch to the network, it got a IP address from DHCP but if I try to connect to this device for configuring the telnet access, I don't succeed to ge...
Hello people,
I have a problem with the ADSL connection on C887VA-K9, 15.4(3)M6a.
The configuration of ATM and Dialer is this:
interface ATM0 no ip address no atm ilmi-keepalive pvc 8/35 encapsulation aal5mux ppp dialer dialer pool-member 2
interfa...
Yes,
the correct flow should be this:
- the client put the right username/password of domain? Go in a Corporate VLAN.
- the client out the wrong usename/password for three times? Go in a FallBack VLAN (Only Internet Access).
- the client doesn't have...
SHOW REDUNDANCY: Redundant System Information :------------------------------ Available system uptime = 1 year, 43 weeks, 2 days, 19 hours, 36 minutesSwitchovers system experienced = 0 Standby failures = 1 Last switchover re...
Hello John,
the switch is new, it has never been used.
The switch is been connected to the network and it gets the IP address from DHCP.
I log in http for configuring the ssh but I don't know the credentials.
I have tried cisco e and password blank b...
Thank a lot for your answer. It's very clear and complete.I'll try to change the IOS at 15.0(2)SE10 and I will see if the problem will be resolved.Leonardo
