Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently have AP Manager working at our central location and clients and wireless are working fine. The network at the main location is 10.1.x.x We have added an additional site and I have configured the AP's for that site on the local subnet whi...
ASDM will not send commands to the firewall. As soon as I click send I get:[ERROR] write memwrite mem^ % Invalid input detected at '^" marker.no matter what the command is. I had 7.2 w/ ASDM 5.1 originally but now 8.0.2 w/ ADSM 6.1. CLI commands from...
We are wanting to move our WAN connections off a 7200 to 6500's. I am trying to determine best practice for configuring of the ports. Right now we have a single 7200 but will be moving to a dual-6509 core. The plan is for most of the connection to go...
I have a odd problem with a new VPN we setup. Its a 2851 <--> Openswan Linux box. They tunnel comes up just fine. On the 2851 side we have a /24 and on the Openswan side we have a /19 and a /26. You can ping from any device in these ranges to any oth...
I have not found a way to do this but I was wondering if I can configure one of the ports on a Catalyst 3020 in a blade server (HP in my case) as a pass-though port to one of the internal NIC's? Anyone know if this is possible? We do not have the pa...
Do you have 10Gb or TwinGig converter? I am going to assume twingig so you'll need to run the command:hw-module module 5 port-group 1 select gigabitethernetbut to match your specific setup.
Seems all I have do is post a forum and I get the answer:http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008073c723.shtml
