Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I don't have a lab environment to test this out in and I was hoping I could get an expert opinion on this topic. I want to privatize the outside interfaces of my ASA firewalls however I need a public IP address bound to an Interface to support L2L an...
I have an RSV4000 which I'm using as a gateway. I changed the default 192.168.1.0/24 network to 10.255.255.0/24 and configured the DHCP address pool to use 64 host addresses starting at 10.255.255.64Every so often users on VLAN 1 get a gateway IP add...
I'm running a 6513, SUP2, MSFC2, PFC2 Hybrid. Extensive policy routing. Feature Manager converts ACLs and route-maps to be hardware switched. I need to get more details on the VMR storage. Whitepapers are too highlevel. Switch(enabled)> sho security ...
Cat 6513 SUP2,MSFC2,PFC2: Im' running in Hybrid Mode (CatOS) and have a rather elaborate policy routed environment (no routing protocol enabled). I need to see how the ACL's are converted and stored as VMRs in the switch. From the MSFC I can see the ...
Can the TCAM on a Catalyst 6500 with redundant SUP2/MSFC2/PFC2 be increased above 32K? Running CatOS (required) upgrading to ver 7.x for order dependent merge. Im performing policy routing between various DMZ's in a split horizon environment with IP ...
Yes I have reflashed the firmware, factory reset and reconfigured several times. The problem persists however, I have identified what triggers it. This occurs when the router is trying to renew its DHCP lease from the service provider. I can reproduc...
The problem with doing port level security is the administrative overhead. Have you considered server security? What resources are you trying to protect?
